What do I need to do for the initial set up and programming of my meter on my Smart Transformer?

You will need to set the voltage and current wiring mode, PT ratio and CT ratio. If no PTs were used, leave this setting as default. Information on the set up can be found in the ‘system parameter setting’ section of the user manual.

If communication is needed:

If serial communication is to be used, you need to set the parity, baud rate and device address of the meter.

NOTE: The default parity, baud rate and device address can also be used.

If ethernet communication is to be used, you need to set the network settings and the device address on the meter; also make sure the baud rate 2 is set as “38400” and parity 2 as “none 1”.